Skip to content

Gas Leak Detection Maryland

Gas leak detection in Maryland finds the exact fitting or length of pipe that is leaking, using gas detectors and a pressure test before any repair begins. The price is fixed up front, a licensed gas fitter does the work, and every job carries our 365-day warranty on all work.

Ring (02) 4063 1093 to book a trace with the gas fitting team, or see the plumber in Maryland home page for everything else.

Licensed plumbers and gas fitters · NSW Lic. 359278C

Last updated September 2026

Gas fitter at work on a kitchen oven

Smell Gas Right Now?

Safety comes before any quote. With a strong smell indoors or at the meter:

  • Get everyone out, pets included where you can.
  • Leave switches alone, keep phone calls for outside, and avoid anything that sparks or burns.
  • From the street, make the distributor's emergency line your first call.

After they have declared it safe, we handle the tracing and the repair inside the property. A faint whiff near a cooktop that comes and goes is worth a call to us too.

Gas cooktop burner alight
Plumber beside a newly installed continuous-flow gas hot water unit

What Are the Signs?

A gas leak shows itself in a few ways, and none should be brushed off:

  • A rotten-egg smell, from an additive put in gas so a leak gets noticed
  • Hissing near the meter, a bayonet outlet or an appliance connection
  • Burners on the cooktop showing orange or yellow flames instead of blue
  • A strip of dead lawn or plants above a buried gas pipe
  • Pilot lights that keep going out with no obvious cause

A leak does not seal itself, and a small one can grow. Tracing it now costs far less than dealing with what an unchecked leak can cause.

How We Find and Repair It

  1. 01

    Isolate first

    We confirm the supply is shut off before testing starts, and nobody works on a live leak.

  2. 02

    Pressure test

    The pipework is pressurised and watched, and a falling gauge shows which section is losing gas.

  3. 03

    Pinpoint it

    A gas detector is worked along that section joint by joint until the leaking fitting is found. Buried lengths are located first with a pipe locator so only the right spot is dug.

  4. 04

    Fix and retest

    The faulty fitting, hose or length is renewed, the pipework goes back under test pressure, and a licensed gas fitter certifies it.

What Shapes the Cost?

The figure rests on:

  • How much pipe has to be traced, since a fault near the meter turns up faster than one at the end of a long buried run
  • What the repair involves, from one perished hose to a replaced section of pipe
  • Whether the leaking length is exposed or needs locating and careful digging to reach

Estate Homes and Gas Lines Past Their Prime

Why the age of the house matters

Maryland was farmland until housing began in the 1970s, and brick-veneer detached homes built in waves up to the 1990s make up most of it, with townhouses added later. Gas fittings, bayonet outlets and appliance hoses from those early build years have now been in service for decades.

Where the weak points are

Rubber seals harden and flexible connections behind cooktops and heaters perish with age, and winter heating in a family home keeps those parts working right through the colder months. If your home still has its original connections, a check before the cold sets in is a sensible precaution.

When We're Not the Right Call

Faults in the street main or the meter itself are handled by the gas distributor, so that call is theirs. From the meter outlet into the house, the pipework, fittings and appliance connections are ours.

What Customers Say

We had an urgent gas problem that required immediate attention at our home…on a Friday afternoon. … Identified the issue, fixed and tested
Lee

Related Gas Work

After a repair, new cooktops, heaters and outdoor gas points belong under gas appliance installation. Leaks in water pipes are a separate job with different equipment, explained under water leak detection.

FAQs

What should I do first if I can smell gas inside my Maryland home?

Get everyone out, leave switches and flames alone, and phone the gas distributor's emergency number from the footpath. When they have made it safe, ring us; one of our gas fitters then chases down and repairs the leak inside your property.

How do gas fitters find a leak without pulling the house apart?

A pressure test shows which section of pipe is losing gas, and a detector then works along that section fitting by fitting until the leak shows itself. That keeps any opening-up to one small spot rather than a whole wall.

Are older Maryland homes more at risk of gas leaks?

Age does matter. Homes from the 1970s to 1990s build waves have fittings, seals and appliance hoses that have aged for decades, and perished rubber or a loosened joint is more likely there than in a house built recently.

Do you repair the leak on the same visit?

If the fault is a fitting, hose or joint inside your property, yes. We fix it, retest the whole line and certify it before leaving. A fault out at the meter assembly or in the road is the distributor's.

Need a plumber? Call or send the form

Call (02) 4063 1093 or send the form below. Available 24/7, you see a fixed figure ahead of any work, and every job carries our 365-day warranty on all work.

Call (02) 4063 1093

Request a callback

Leave a name and number and a plumber will ring you back.

We use your details only to call you back about this job. See our privacy policy.

Call (02) 4063 1093 Get a quote